网站转让 → 您的公司名称

混凝土排水渠模具施工填仓时，在不影响工序安排的情况下，应宁晚勿早，施工缝和相邻板的施工缝不能设在同一断面上，以防挤掉边角；混凝土排水渠模具浇筑完成后拆模不能过早，要有一定的强度后才能考虑拆模，拆模时不能硬砸，硬撬，严格按操作规程要求进行拆卸；拆模后要及时注意保湿养护，不得给其承重受压等；铺筑填仓混凝土板时，两侧正在养护中的混凝土板盖上一层土工布，不得揭得过早过宽。
When the concrete drainage channel mold construction filling warehouse, under the condition that the process arrangement is not affected, the construction joint and the construction joint of the adjacent slab cannot be set on the same section to prevent the corner from being squeezed out; after the concrete drainage channel mold pouring is completed, the formwork can not be removed too early, and the formwork can be removed only after it has a certain strength. When removing the formwork, it is not allowed to smash or pry hard, and strictly comply with the requirements of the operation regulations The concrete slabs under maintenance on both sides should be covered with a layer of geotextile, and it is not allowed to be exposed too wide.